Keshe台灣凱史知識尋求資料館 - 繁體中文 (非官方組織 /官方資料)

你可以做任何保健品/維他命或營養補充品的甘斯。事實上，舉凡你環境所見可取材之物，都可做成甘斯。

請遵循以下步驟：
膠囊：打開藥丸或維他命膠囊，將裡面的東西，倒到一個小容器
錠劑：壓碎一顆錠劑，成為粉狀，倒到一個小容器

準備內容物的比例，有兩種做法：

#方法一
加入¼茶匙(量匙)壓碎後的維他命，放入量杯
¼茶匙乾燥氫氧化鈉，加入量杯
5茶匙沸水，加入量杯(直到你看完所有指示再做)

#方法二
藥丸量與氫氧化鈉，等量混和
加入沸水，上述乾粉與水的比例1:10

#開始奈米塗層過程：
確保乾粉混和
加入沸水到乾粉，很快蓋上密合
氫氧化鈉將開始產生奈米物料
擺在一旁封緊，約3-7天
清洗甘斯混和物
3-7天後，打開容器，以蒸餾水清洗混和物(見清洗甘斯)

#加入CO2甘斯：為完成過程，加入一些CO2甘斯，約10ml到洗過的藥丸或維他命甘斯 (注意請勿觸碰甘斯任何部分)

#補充說明(by Mark House)
奈米堆底下的水，就是你剛剛放的維他命的類比物。是有場域的等離子體，轉移你放的源頭物質(比方：維他命)到甘斯，從甘斯與氨基到水。

有油的東西，如果浮上來，可以用法式濾壓壺去圍捕。或是替代用法，你可以把新的油放在小容器，放在你想拿的水的外面或裡面會更容易。使用橡皮筋或透明膠帶將，將小安瓶固定在在玻璃或容器外。

甘斯的氨基，油，鹽都是場域等離子體的散發物，所以接近是個考慮點。你的氨基以及甘斯油鹽等等應該靠近，才有場域飽和的效果，才會最有效。所以純粹喝它或蒸發它。

純為知識分享，請斟酌閱讀

How to Make the GANS of Pills and Vitamins
This is the approved revision of this page, as well as being the most recent.
Jump to: navigation, search

Powdered Vitamins on a spoon.
Hard Tablet on a spoon.
You can make and use the GANS of any pill, vitamin or supplement that is available to you. As a matter of fact, you can make the GANS of any substance that you can find in your environment.
To make GANS of pills or vitamins (tablets or capsules), please follow these steps:
Capsules: Open the pill/vitamin capsule and pour the contents into a small container.
Tablets: Crush a hard tablet into a powder using a pill crusher and pour it into a small container.

Prepare the Ingredient Proportions: There are two methods that can be used:

First method:
Fill a ¼ tsp. measuring spoon with powdered vitamin and place it in a mixing cup. Measure out ¼ tsp. of dry caustic (NaOH) and add it to the mixing cup (use a mixing cup or container that can be tightly sealed). Mix the powders well.

Add 5 tsp. of boiling water to the mixing cup (please do not add the boiling water until you have read all of the instructions below).

Second Method: Match the quantity of the pill to that of Caustic. Mix and measure the dry ingredients. Add boiling water to the powder at a ratio of 10 parts water to 1 part mixed powder 10:1.

Start the Nano-coating Process: Ensure the dry powders are mixed. Add the boiled water to the dry ingredients and quickly tightly cover the container. The caustic (NaOH) will begin creating the nano material. Let stand, tightly sealed, for 3-7 days.

Wash the GANS Mixture: After 3-7 days have passed, open the container and wash the mixture with distilled water (see Washing GANS).

Add CO2 GANS: To finish the process, add some CO2 GANS (roughly 10ml) to the washed pill/vitamin GANS. (CAUTION: never touch GANS with any part of the body).

comments from Mark House
The water from the nano clusters below (your gans) now becomes your analogue of the vitamin, etc.

It is field plasma and as such transfers the fields of your source matter to the Gans, and from the gans and aminos to the waters.

With oils - if it floats then trap with a French coffee plunger adapted to force the oils below the water surface. Or, alternatively you could place the new oil in small containers and place outside or inside the waters you want to infuse, which is much easier. Use rubber bands or clear tape to hold the small ampules on the outside of your glass or container you choose for your different types of gans medications.

The aminos and oils, salts, of the gans are field plasma emitters, so proximity is a consideration. Thus, your aminos and Gans oils, salts, etc., should be close by to have the effects of the field saturation to be most effective.
So simply drink it or vaporize it.

https://m.facebook.com/story.php?story_fbid=1383840341761864&id=100004077343662